The radical new Revo-DHC is a downhill race pedal which gives all the control benefits of a flat pedal, with the security and pedalling efficiency of a clip pedal. Featuring an extra-large body and fully adjustable pin height, the Revo-DHC gives unparalleled levels of support, feedback and control. The proprietary Renthal binding features easy entry geometry, a huge range of spring tension adjustment and is fully SPD compatible. This pedal is unconventional and uncompromising, but for all the right reasons. Features Extra Large Body: Sharing the same silhouette as the proven Revo-F, the Revo-DHC gives the same support, feedback and control of a flat pedal, whilst having the extra security and pedalling efficiency of a clip pedal. Adjustable pin height, from 1.5mm all the way up to 5.5mm, in 1mm increments, ensures the widest range of shoe compatibility.. Proprietary Binding: The Renthal developed binding uses easy entry geometry. This allows the rear jaw to move down and away from the cleat on engagement. The effect is a reduction in the force required to engage the cleat for a given spring tension. The bindings feature a huge range of spring tension to suit any rider’s preference. Renthal bindings are fully SPD compatible.. Axle System: The patent-pending axle system, featured in the Revo-DHC, allows full home servicing, using standard tools found in anyone’s toolkit. All that is required is a 6mm and 8mm hex-key, a standard 8mm socket, a torque wrench and a mallet. The unique system uses the axle to both remove and reinstall the bushings. The bearings are also pressed into place, using the pedal internals.. Durable Internals: Inboard, the Revo-DHC spins on an extra-wide Igus bus, sealed with a full-contact wiper seal. Outboard, there are three cartridge bearings. Two smaller bearings and a larger bearing in the outermost location, sealed with an end-cap-O-ring. Adding to the durability of the bearings is the full-length axle. Mounting the bearing at the outer edge of the pedal gives them the best support to protect them from damage in a rock-strike incident.. Forged CNC: The main body of the Revo-DHC is made from forged, 6061 aluminium. The pedal is then fully CNC machined to remove as much material as possible. To improve rock-strike performance, the front of the pedal has been kept smooth, without any cut-outs. This allows the pedal to slide over rocks, rather than grabbing at them.. Specifications Revolutionary extra-wide 104 x 111mm 6061 body, with CNC machined finish.. Adjustable pin height for shoe compatibility – 1.5mm to 5.5mm, in 1mm increments.. Proprietary Renthal binding, with easy-entry geometry.. Super wide range of tension adjustment, for all preferences and uses.. Triple cartridge bearings, mounted outboard for ground-strike durability.. Inboard Igus bush, with Patent Pending Renthal easy service axle system.. O-ring sealed end cap and full contact wiper seal, inboard.. 55mm crank to binding distance (same as the Revo-TRC).. SPD cleat compatible (supplied with Renthal cleat).. With standard pin configuration, 622g per pair..
Increase your pedal power today with this leading product available from Merlin Cycles.
